Below is the example of the drawing seeds that have been deleted. For some reason they are still showing up in the drop-down menu. Is there a directory where I need to delete them to only show the ones that are truly active?
Joseph:
These seeds are dgnlib files, by default found at C:\ProgramData\Bentley\OpenRoads Designer CE 10.11\Configuration\Organization-Civil\_Civil Default Standards - Imperial\Dgnlib\Sheet Seeds\Road\*.dgnlib or C:\ProgramData\Bentley\OpenRoads Designer CE 10.11\Configuration\Organization-Civil\_Civil Default Standards - Imperial\Dgnlib\Sheet Seeds\Rail\*.dgnlib. Assuming that your dgnlib's are still located here, if you move them or remove them from this location, they should "disappear".
Mark
It seems like I may have misunderstood the issue here... I will look into this issue further.
I found on my local project wise local drive they are being backup here I just deleted some and only a few are showing from project wise I will check to see where the other ones that were deleted in project wise are being stored, I think that is where the issue is. I also noticed that our work sets are connected to configure when loading any relevant files.
thanks for the feedback, Mark as always appreciate you.
It looks like someone has produced a lot of customization which does not seem to be needed.
Matthew has some good ideas below...