Hello,
ORD CE 2021 R2 Version 10.10.21.04
I've set up a file to cut a cross section at an entrance on my roadway project. When cutting the cross section I noticed the 3D graphics from the entrance (a civil cell referenced from another file) weren't appearing. Turns out the Default model was referenced to my x-sec file, but the Default-3D model didn't follow. The Default-3D isn't listed in the references for the 3D view while it IS listed in the Default list. Further experimenting I detached the geometry file of the entrance only to find that the Default-3d model didn't detach. Pic below: Default view on left, Default 3D on right.
How can I stop these models from attaching and detaching independently? The entrance and geometry files reference normally to other files (both Default and Default-3D models attach). I've used this exact workflow before without incident. Any help is appreciated. Thanks!
Check to see if any of the files are referenced with the Ignore Attachments when live Nesting toggled on. I experimented with making that a default for normal reference files but found it got applied to the Open Roads attachments and created a similar situation.
Charles (Chuck) Rheault CADD Manager
MDOT State Highway Administration