Create Cut Fill Volume - Unsuitable Material Takes long timehttps://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/241979/create-cut-fill-volume---unsuitable-material-takes-long-timeGreetings I am using openroads 2020 Release 2 for a project . I am creating Cut fill volumes from Civil Analysis. I have only 5-6 short corridors (100-200m long) to analyze which is in an attachment file. I have also ensured there is not any unwanteden-USTelligent Community 12RE: Create Cut Fill Volume - Unsuitable Material Takes long timehttps://communities.bentley.com/thread/754389?ContentTypeID=1Wed, 22 Feb 2023 09:09:23 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:423a9e62-67f5-4b6b-92cb-284631f93f58Ramanan R<p>Thank you for the Response. I don&#39;t have the old terrain referenced. I just have the corridor file attached with No Nesting toggled on. The corridor file too has only the corridors and no existing terrain.</p><div style="clear:both;"></div>RE: Create Cut Fill Volume - Unsuitable Material Takes long timehttps://communities.bentley.com/thread/754378?ContentTypeID=1Wed, 22 Feb 2023 07:55:34 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:aaca252f-a928-471b-a0fd-bdb22c5a45deMark Shamoun<p>Hi,</p> <p></p> <p>You don&#39;t still have the old terrain reference attached or any non-displayed references with large data sets in them? I don&#39;t believe this tool honours reference (or level) display visibility so that could be causing the issue?</p><div style="clear:both;"></div>