ORD 2021 R2
I'm sure this is an easy one. When rotating a line how can I go clockwise using active angle or construct by angle? How to measure the obtuse angle and how to label the obtuse angle? Plats go clockwise sometimes and I can't get the 360-angle to work when using dms.
Thanks
You can type a negative angle into the active angle field and MicroStation will calculate the angle, or you could go into the Design File Settings and toggle the Clockwise direction. The angle dimension will label both side of the angle between two lines.
Mike LongstreetVermont Agency of TransportationCivil Engineering Technical SupportVTCAD Help
Not too bad, been a while since I dimensioned an angle. Sort of sucks to have to dimension something when there is a measure angle tool, but will only do acute. I can do the math but...should I have to? Well as Meatloaf said "2 out of 3 ain't bad".
Thanks for the help