How do I annotate definition for my complex geometry to annotate PVI and PI (station and elevation, where applicable)?
The annotation definitions I currently have only, only annotates the intersections with curves applied to them.
On the vertical geometry, the grade breaks are displayed with a marker like a circle or triangle. And i'd like to add the station and elevation.
On the horizontal geometry, nothing is added at all.
This topic is not new - RE: ORD Horizontal Annotations for NON CURVE PI Points
But the solution has varied from version to version. I am running into the same\similar issue but with version 2022 10.12, when using Horizontal Points - P.I - All Curves only the curve PI's are labeled but if Horizontal Points - P.I. is used all curve PI's and none curve PI's are labeled.
Another option is to use In Horizontal Components - Arc Left or Arc Right and then switch the Components option to Point of Intersection which will only label curve PI's. There is an option of Horizontal Components - Line with a Components option of Point of Intersection which you would think would work but it does not because all PI's are labeled.
Another option is to used Horizontal Points - POT but you would then have to set the config variable CIVIL_LABEL_POT = PI so that non curved PI's would be labeled as PI and not POT.
Just seems there is not one clear cut solution to this. I would like to see this enhanced to just have one option of a non curve PI as a selection when applying annotation definitions.
Sean Keene