Superelevation Lanes

RE: Superelevation Lanes

Shawn Cooke — Thu, 27 Apr 2023 10:56:24 GMT

Glad you figured it out! Sorry for the late response here! Here's a similar post that may help in similar situations... RE: [ORD 2022 R1] Superelevation Lanes Offset from Dynamic Origin

RE: Superelevation Lanes

caddcop — Tue, 25 Apr 2023 13:18:34 GMT

I have on occasion found a need to use a point control to tie a template point to the alignment that would usually be automatically attached to the centerline point of the template. This gives you even more flexibility than simply always having the origin of the template applied to the centerline alignment.

RE: Superelevation Lanes

Dylan Repass — Tue, 25 Apr 2023 02:40:25 GMT

Justin,

Thanks for reaching out! After a few painful hours I finally discovered the issue. The template's origin was offset 0.010 to the left and for that reason the R_EOP coordinate was less than 12 at 11.990 whereas the L_EOP was at 12.010. Although the R_EOP was indeed constrained 12ft horizontally from the CL, I assume the software did not like that. The fix consisted of clicking on the CL point and selecting the reset origin command.

Best, Dylan

RE: Superelevation Lanes

Justin Guiliano — Mon, 24 Apr 2023 13:21:52 GMT

Are your PC assignments correct? When you calculated SE, what pivot method did you select?