You can see in the image below that CB 9 does not display baseline station and offset although it is setup correctly in the properties. If I re add the baseline reference it will then break the station and offset from 2-5 other catch basins. The only way around it is to select all the catch basins at once and then add baseline reference again. But it I move anything or add a catch basin they break again. It is very frustrating. Does anyone else have this problem??
I have come across the same issue were you able to find additional information on this error?
I have not found a solution. My work around so far is to make selection sets for each alignment I have in the project. Then go through each selection set and re-associate the reference alignment for each set. Then the flex table usually shows all stations and offsets at the same time. Very frustrating process.