I am trying to generate reports of the lane lines and the edge of pavement lines off of the centerline at 25 ft intervals and not having any luck. I am using ss 10 with open roads technology.
The mentioned reporting tool will ask for two selections (two steps). You can either select a profiled 2D graphic both times OR select your Corridor's alignment 1st then the EOP linear feature next (Tool prompt will say Locate First Offset Element). However, if you don't see 2D Linear Features being made by your corridor, check the properties of your Corridor Design Stage. If Linear Features Display option is set to False, you may not get the ability to select that 2D EOP graphic produced by your corridor. The report tool will also allow selection of the mentioned EOP graphic both times, but will start at zero and not report the stationing used by the corridor (ie. Alignment selected during the first prompt). To get a better idea how the tool works, here's a video (but not in the context of a corridor). https://www.youtube.com/watch?v=DbRVp-6vEH0
Bentley Accredited Road Designer | Bentley Accredited Road Modeler
colliersengineering.com
Answer Verified By: Paul Pare
V8i still has access to corridor design stage standards under "Civil Standards" and "Project Settings" (File dropdown menu > Project Explorer). You may need to switch the design stage to one with the setting enabled. Also change the report to the one highlighted below to get elevations based on intervals.
I cannot change the design stage not sure why? I do not have the option to switch the corridor to a different design stage not sure where to get it?
Hover your mouse cursor over the corridor handle in the view window, wait for the context menu to appear, select the first properties icon, a small dialog will appear giving you the option to switch it there.
Have you seen this error before? The profile is attached in the drawing?
Don't you mean the Alignment file?..........Make sure the vertical is active?
Joe Lukovits