Hi everybody
I have scale bar from 0 to 50 on the drawing (see the picture 1 below). But it should be from 0 to 20 (se picture 2 ). Does anyone have any ideas how this can be fixed?
There was a post not long ago discussing this topic that may help. It mentions creating a bar with text favs tied to the length of each segment of the scale bar... mentioned by Bob Rayner in the following MS forum post. Dynamic scalebar However, he does suggest having his sheets "actual scale". There may be a similar method to place these dynamic scalebars in the drawing models for correct scale since by default the Sheet models are 1=1 *full size respective to the intended sheet size (e.g. ANSI-D 11x17, etc).
Bentley Accredited Road Designer | Bentley Accredited Road Modeler
colliersengineering.com