I am unable to change the invert elevation on any of the nodes I have placed. I am able to hard key in a value, but after I do so, it changes the invert elevation to exactly 7.25, it does this exact thing for every node. I tried to see if the 7.25 referenced somewhere else, but was unable to.
Andrew:
It seems to me that the definition for this node has a minimum value of 7.25. You could test this by changing the elevation of the node to a difference larger than 7.25; i.e., an invert of 0 and a top of 10. It should "expand" to this difference, but will be unable to "contract" to a difference less than 7.25.
Best Regards,
Mark
It is able to be a value that is greater than a difference of 7.25. So, for one with a rim elevation of 421.60, I am able to make the invert elevation 0-414.35, but unable to make it any value between 414.35-421.60. I need the invert elevation to be 4.5 less than the rim elevation. Is there a setting to change this?
If the sum of the top 3D cell and bottom 3D cell equals 7.25, then you cannot decrease that total depth. You will need to create a different set of 3D cells that will allow a shallower structure.
Karl Dauber, PEAdvance ConsultingLaurens County, SCkarldauber@advconsult.netwww.advconsult.netwww.linkedin.com/in/karldauber