I don't think I've had this issue in the past but when I do a 3D cut on the profile of a line through a bunch of 3D cut/fill solids generated by ORD using the Create Closed Mesh tool, other things show up from the 3D model but not the cut/fills.
Hopefully I'm missing something easy but I've not done it since upgrading ORD, 3D model and profile below:
Any ideas?
Hi Ken,
These are construction class by default. Could that be the issue?
Regards,
Mark
OpenRoads Designer 2022 R3 (10.12) | Microstation 2023 | ProjectWise CE 3.4
Answer Verified By: Ken Bagnall
I've just discovered that actually, if I change them to primary class they now show up.
The question is should they be construction class or is there a way to show construction class elements in 3D cut?
Construction class elements can be turned on or off by means of a View Attribute. Make sure that "Constructions" is turned ON for your view, and they should show up. Often, Constructions are off by default.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
I'm sure I checked it was on for the Profile view and 3D model but I will check again.