I was wondering if anyone knew of a good way to annotate structures in a Drainage Profile. I would like to get all of my inverts labeled at each inlet or manhole and have it display the pipe size at for each of these pipes. I have been able to get the invert elevations and directions (N, S, E, etc.) to display but haven't figured out a way for the pipes sizes to display. I am currently doing the edits by hand and have to refer back to other documents to figure out the sizes for each pipe which is rather time consuming. I'm attaching a picture of what I would hope to see happen.
IR 8.08.00.46
Thanks, Neal
Neal, Give this a go, Evaluation > Profile > Annotate Drainage Profile, then toggle Structure Type to Pipes, turn on & modify the settings for height, ie - the height is pretty much the pipe diameter...........
See attached image, showing standard VicRoads config, cheers, hope this helps Geoff W..............
Geoff,
I should have mentioned that I did try that but from what I saw it only displays the height for the pipes shown in the profile (i.e. mainline) and not for any of the other pipes at a structure for example pipes coming in from a different trunk line or from an inlet. So it gets me closer but the size of the pipes that would be really helpful are still not displayed.