OpenRoads | OpenSite

OpenRoads | OpenSite Forum Civil Geometry - Fitting fixed length line between two divergent elements.

Civil Geometry - Fitting fixed length line between two divergent elements.

Offline Robert Garrett over 13 years ago

Have you ever had a situation like this where you need to fit a fixed length line between two non parallel elements?

This is actually quite easy to do:

Parents

Offline Malin Spångberg Wed, Jun 24 2015 5:12 AM

Hi,
This is very helpful, but I can't seem to make it snap to the line I want. I get the message "Element not valid for tool".
I'm not sure if it matters but the lines I'm trying to use are in a refrencefile.
I've followed your instructions from the film, but get the feeling there is something wrong. I'm using PowerCivil v8i.
I'm a beginner at this, so the problem might be something ridiculous.

/Malin.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Offline Jacquelyn Pettus Mon, Jun 29 2015 3:07 PM in reply to Malin Spångberg
Which command are you using when you receive the "Element not valid for tool" command?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Offline Jacquelyn Pettus Mon, Jun 29 2015 3:07 PM in reply to Malin Spångberg
Which command are you using when you receive the "Element not valid for tool" command?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data