Geopak Troubleshoot using Roadway Tool in Site Modeller

I am trying to model a very simple site consisting of three roads connected to one another.

I cannot seem to get the kurb returns to model in the Roadway Tool using the preferences I am specifying (Search Distances not correct perhaps). Thus I cannot complete the model. I have been tasked to learn this software we acquired and teach it to my collegues.

Any help would be greatly appreciated

 

Lloyd Wallace

Ilifa Engineers SA

Parents
  • You might want to post your dataset for analysis.

    • the search distance for curb returns is measured from the intersection of the two roads.
    • draw a circle centered at the intersection point.  If the circle encompasses both ends of the curb return then the search distance is adequate
    • make sure the symbology of the returns matches the plan symbology you entered in the preferences

     

    Robert Garrett
    Senior Product Engineer
    Bentley Systems Inc.



Reply
  • You might want to post your dataset for analysis.

    • the search distance for curb returns is measured from the intersection of the two roads.
    • draw a circle centered at the intersection point.  If the circle encompasses both ends of the curb return then the search distance is adequate
    • make sure the symbology of the returns matches the plan symbology you entered in the preferences

     

    Robert Garrett
    Senior Product Engineer
    Bentley Systems Inc.



Children
No Data