Modeling Existing Utilities in InRoads XM

Thanks in advance for any help or advice.

I am looking to model a set of existing utilities inside of Inroads XM, using the drainage utility command.

The Utility that I have currently modeled, as a trial run to figure out the best work flow, represents an existing

rectangular drainage culvert.  The culvert was created successfully in the utilities tab and shows when viewing

drainage as solids.  My issue now is I want to see the existing Utility show up in my Profile when i cut it along

my horizontal alignment.  to this point i cant seem to get the crossing of this utility to show.  Therefore my

question is....

How do you get Utilities to show as crossings when creating Profiles or Sections?

Does this information have to be brought into the DTM as a Feature for it to show?


Enough for now...

Thanks again for your insight and direction


Best Wishes,
Kevin.