Hello, I have been trying to figure out how to create a border for my cross sections, so when I cut all 200 of them, they will have a border. I have referenced in a border, it is portrait, 11x17. I want to have 6 cross sections per page, total left to right off set is 200. under the Layout->General, I have it at Sheet. ->Spacing, 6 sections per column, and this is were I get confused for the rest. when I try and run, it says that Range of Cross Section (200,40) is greater than Sheet Border(60,260). When I just reference in the .DGN, it will allow me to move the cross sections into place, 6 vertical, and they all fit. With this many cross sections, referencing in all those borders and moving the sections around takes a lot of time. Let me know if you can help.
Thanks,
Tom
This message is (60, 260) is saying your sheet setup allows for 60units wide by 260 units high. It seems some where you have the Horizontal X Vertical mixed up. You say you have the border set for portrait but the first number is the X axis to (200,40) look like landscape to me. HTH.
Mike LongstreetVermont Agency of TransportationCivil Engineering Technical SupportVTCAD Help