I am working on a project where I have been trying to add an end condition override in a superelevated section of a road.
In this first picture I have the roadway modeled fine except I want the short slope on the right to go down instead of up. So I created an end condition exception for this area.
When I apply the end condition exception I get the following.......
You can see the contours become jagged in this area and the second picture shows the features a created with a hump.
I can't figure out why this is happening in a superelevated area. It is a simple 2 lane road. There is only 1 template. This also happened a little further up the road where there is a structure. I created an EC exception so the modeler would remove the slopes. When it came to the structure there would be a jump in the features and the contours would be jagged. The only way I could prevent that from happening in that area was to copy my template and remove the end conditions from the template. Even defining the EC to use backbone only did not rectify the issue.
Does anyone have any insight? This only happens in superelevated areas.