https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/76766/roundabout-designI am undertaking a Roundabout Design using the associate alignment method (associating Construction Lines of the legs to the crown line on the circulatory carriageway). After associating the two strings, I go to the vertical design panel to carry outen-USTelligent Community 12https://communities.bentley.com/thread/208642?ContentTypeID=1Fri, 11 May 2012 13:03:59 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:619cdb1e-6a23-4b16-90b1-6060c75d7e65Kenny12<p>Mark,</p> <p>Thanks for your prompt response.</p> <p>I&#39;m using MXRoad V8i (SS2).</p> <p>I think i have been able to get around the problem. &nbsp;I did a vertical design on the construction line (just the same as doing vertical design on any alignment) prior to associating it with the circulatory carriageway crown line.</p> <p>Once i associated the two alignments and when i come to do the vertical design, i can select the vertical profile of the construction line and amend it as required.</p> <p>Ash</p><div style="clear:both;"></div>https://communities.bentley.com/thread/208573?ContentTypeID=1Thu, 10 May 2012 20:34:43 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:21e83729-6dfe-4d92-a8ac-80ecd83f442eMark Marnell<p>Are you using MXRoad? </p> <p>When you associate multiple alighnments, you need to select them all (one by one) so that the corresponding ground prile can be drawn, before you then start the vertical design.</p><div style="clear:both;"></div>