[mx road] problem with divided carriagway

Re: [mx road] problem with divided carriagway

sreenivasbachu — Sun, 22 Jul 2012 17:36:32 GMT

Thanks Mr.Mark Marnell

what you you said is obsulutely correct overlaping stringd in plan is not allowed in Mx i manged to get by providing small offset.

Thanks you very much.

Sreenivas Bachu

Re: [mx road] problem with divided carriagway

sreenivasbachu — Sat, 21 Jul 2012 21:00:02 GMT

Thank your reply Mr. Mark Marnell

OK agreed but i got one time i made it by above line mode it is possible only. when i am making next time there is a problem. I will not leave this here i will try to make it . Please you try you may get it.

Regards,

sreenivasbachu

Re: [mx road] problem with divided carriagway

Mark Marnell — Sat, 21 Jul 2012 17:19:26 GMT

When taking cross-sections, you should not have vertical faces i.e. strings should not be in the same plan position with different levels. This also is true when triangulatiing a surface - no vertical faces allowed.

Ensure your strings have a 2mm horizontal offset - you may be just getting lucky with the right median, but it should have an offset.

Re: [mx road] problem with divided carriagway

sreenivasbachu — Fri, 20 Jul 2012 22:34:21 GMT

Mark Marnell.

i have you find that is problem.

Sreenivas

Re: [mx road] problem with divided carriagway

sreenivasbachu — Wed, 18 Jul 2012 22:20:42 GMT

yes it is problem of cross section at the center-line Right is ploting RCR0 ,0.15 above MCR0 but left is not plotting LCL0 0.15 above MCL0. In fact whatever i am making for LCL0 is applying for CEL0. I tried so many times but always failed.

Sreenivas

Re: [mx road] problem with divided carriagway

Mark Marnell — Wed, 18 Jul 2012 17:08:45 GMT

What exactly is your problem? Is it when taking the cross-section of the median?