Corridor Modeling Cross-Section Missing Elementshttps://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/83267/corridor-modeling-cross-section-missing-elementsI&#39;m cutting cross sections using the Cooridor Modeling tool in Geopak 08.11.07.536. When I cut my sections from the DTM there are places where elements are not showing. The point labels show up, but not the line work. It&#39;s not consistant and all levelsen-USTelligent Community 12Re: Corridor Modeling Cross-Section Missing Elementshttps://communities.bentley.com/thread/235633?ContentTypeID=1Sat, 23 Feb 2013 01:24:58 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:f08b76ff-b925-4215-ab87-36ffbeade49cMikeHarvison<p>I&#39;m in the middle of creating a DTM right now and cannot check, but I don’t think Variable Manager is implemented in Geopak Corridor Modeler. &nbsp; Using Corridor Modeler (SS2) is like using InRoads without all the little tools that help (like being able to edit a DTM). </p><div style="clear:both;"></div>Re: Corridor Modeling Cross-Section Missing Elementshttps://communities.bentley.com/thread/235610?ContentTypeID=1Fri, 22 Feb 2013 22:02:37 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:cb76a17b-2522-43fa-bd82-bf4e6a398327Mike Longstreet<p>If you are not seeing components in some areas in particular areas where the components are somewhat irregular or non perpendicular to the geometry there is variable to &quot;Use Mesh Algorithm for Cross Section Components&quot;&nbsp; when this is toggled on the components will display more consistently in cross sections.&nbsp;</p> <p>Variable Manager under - Command Behavior:</p><div style="clear:both;"></div>Re: Corridor Modeling Cross-Section Missing Elementshttps://communities.bentley.com/thread/235507?ContentTypeID=1Fri, 22 Feb 2013 03:34:41 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:02605523-972d-43f8-9b60-f1613a636e51MikeHarvison<p>I am getting the same near transition areas that have not been cleaned up. Is this what you have found?</p><div style="clear:both;"></div>