SELECTseries 3 and Workspaces

I received a tip last week from Derricke Gray on a good idea for additional Project Settings - Design Stages.  We added 4 new design stages to the Bentley-Civil Example Workspace that will be available in our next release.  We added one for Top Mesh Only, Bottom Mesh Only, Linear Features Only, and Components Only.  These are all Final design stages and make it a lot easier to get the correct information for machine control and terrain model creations.  If you want an updated copy you can get it here.  Note the paths are setup for Power GEOPAK, but it works for PG, PI, Inroads and GEOPAK Suite and MX.  Just update the files that were delivered with your install after unzipping.  

ftp.bentley.com/.../SS3Standards_05_21_2013.zip

Note, as we continue to update our example workspace I will continue to update this thread.  Note, the posted link will be good for a few weeks.

Thanks,

Chuck

Unknown said:

Note, the posted link will be good for a few weeks.

Hi Chuck -

The link is dead already.  Can you repost a new one? 

Thanks.

With the pending SS3 MR release, I wanted to share with you the changes coming to the Bentley-Civil Examples Workspace.  I am very excited about these changes and hope you will be as well!  Please see the attached file. 

Additionally, the latest version is here and should match up with the released version.

ftp://ftp.geopak.com/pub/outgoing/Chuck/SS3Standards_03_03_2014.zip

One small update...  We are setting the default for Live Nesting Depth to a value of 1.

ftp.geopak.com/.../SS3Standards_03_05_2014.zip

Hey all, one small report.  I found out I made a mistake in the examples workspace you all need to be aware of.  I mixed survey feet with international feet between seed files and dgnlibs.  This will cause computed values such as contour labels and stations to be converted. So for example you may see a contour label to be 299.9996 instead of 300.  Make sure your dgnlibs and cell libraries match the units of your seed files.  I will post an update for the workspace soon here.

Thanks

Chuck  

Hey all, one small report.  I found out I made a mistake in the examples workspace you all need to be aware of.  I mixed survey feet with international feet between seed files and dgnlibs.  This will cause computed values such as contour labels and stations to be converted. So for example you may see a contour label to be 299.9996 instead of 300.  Make sure your dgnlibs and cell libraries match the units of your seed files.  I will post an update for the workspace soon here.

Thanks

Chuck  

Hey all, one small report.  I found out I made a mistake in the examples workspace you all need to be aware of.  I mixed survey feet with international feet between seed files and dgnlibs.  This will cause computed values such as contour labels and stations to be converted. So for example you may see a contour label to be 299.9996 instead of 300.  Make sure your dgnlibs and cell libraries match the units of your seed files.  I will post an update for the workspace soon here.

Thanks

Chuck  

Hey all, one small report.  I found out I made a mistake in the examples workspace you all need to be aware of.  I mixed survey feet with international feet between seed files and dgnlibs.  This will cause computed values such as contour labels and stations to be converted. So for example you may see a contour label to be 299.9996 instead of 300.  Make sure your dgnlibs and cell libraries match the units of your seed files.  I will post an update for the workspace soon here.

Thanks

Chuck