• State Verified Answer
  • Replies 2 replies
  • Subscribers 141 subscribers
  • Views 3792 views
  • Users 0 members are here

Getting Elevations from Surface for Cogo Points

Imad Balich

Hello there!

I was trying to Get some Elevations from a Surface for some Cogo Points by creating a clearance report from the specified Surface, The issue is that when i checked the Northing & Easting of the Cogo Points, they were different than the specified ones, which means the elevations are not obtained rightly, so is there any way to get this thing right.

Thanks & Regards,

Parents
  • 0 Offline

    Hi,

    Would you tell me how you are verifying your Northing & Easting?  Are you comparing the data from your clearance report to a Geometry Report?  Are you selecting Geometry>Cogo Points>Edit Cogo Points and selecting your specified ones? Are you perhaps selecting the Cogo Buffer and then the Review option or the detail pane? All of which should yield the same results.  However; when snapping to geometry points, be mindful of your snap settings at Tools>Locks (No Snap, Point Snap and Element Snap).  You may also want to verify you MicroStation Locks as well.

    If this doesn’t help, I’d be happy to create a short video for you!

    Thanks,

    Sanders

    For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki



    Answer Verified By: Imad Balich 

Reply
  • 0 Offline

    Hi,

    Would you tell me how you are verifying your Northing & Easting?  Are you comparing the data from your clearance report to a Geometry Report?  Are you selecting Geometry>Cogo Points>Edit Cogo Points and selecting your specified ones? Are you perhaps selecting the Cogo Buffer and then the Review option or the detail pane? All of which should yield the same results.  However; when snapping to geometry points, be mindful of your snap settings at Tools>Locks (No Snap, Point Snap and Element Snap).  You may also want to verify you MicroStation Locks as well.

    If this doesn’t help, I’d be happy to create a short video for you!

    Thanks,

    Sanders

    For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki



    Answer Verified By: Imad Balich 

Children
Communities
Support and Services
Training and Learning
Social Media