Geopak V8i 08.11.07.615
I'm running Geopak Earthwork on cross sections and am constantly getting the "XS-W-DANGPROP Proposed undercut element between points:..."
The earthworks ran fine in Geopak v8.
I tried unlocking all elements and adjusting the tolerance both ways with no improvement.
Existing ground is composed of lines (as opposed to line strings).
Even after modifying and snapping to the lines, I get the errors.
Any ideas?
The code for GEOPAK Earthwork was changed from the 08.11.07.246 version to the newer versions 08.11.07.494 and above.
When the DGN elements are selected before processing traditional GEOPAK EW, a subset of code was written to remove duplicate elements if they are vertical or they turn-back on themselves. This was done for the processing of closed components in Corridor Modeler.
As a workaround there are a couple of options:
1. Make the lines so they are not quite verical.
2. When 2 sets of vertical lines are drawn in the same position, break the lines so they are not exactly the same.