InRoads S&S HGL Display on Profile

The first thing to check would be to make sure you have good elevations in Table A of the design log.  What does your Table A look like for this network?

See below

OK... now that we have verified that the HGL has been calculated for these structures, we just need to confirm the following:

1.) These structures listed in this design log are the same structures being profiled

2.) The elevations of the HGLup/dn listed in the design log are elevations that are displayed in the profile range.

3.) The symbology defined for the HGL on the Network tab is drawing on a level that is turned ON in MicroStation.

If you have confirmed these 3 items and it still does not display, it might be helpful to post your SDB and XIN file for us to test.

OK... now that we have verified that the HGL has been calculated for these structures, we just need to confirm the following:

1.) These structures listed in this design log are the same structures being profiled

2.) The elevations of the HGLup/dn listed in the design log are elevations that are displayed in the profile range.

3.) The symbology defined for the HGL on the Network tab is drawing on a level that is turned ON in MicroStation.

If you have confirmed these 3 items and it still does not display, it might be helpful to post your SDB and XIN file for us to test.