Hello, Is there a way to list (or edit the list of) the stations that the Roadway Designer has for each corridor? Going through design, you may enter an odd station for a cross-drain or look at an event point for an intersection that later gets moved, etc. Later in the design when you are looking through the sections, every one of these stations you ever looked appears to be included. On a long alignment that has had multiple iterations, etc. this leads to a lot of excess/unnecessary stations in the list. How can I see or edit the list of stations that the corridor displays in the Roadway Designer? I'm a new InRoads user so please be as detailed as possible in any response.
Thanks for your time and assistance.
Edit: Using InRoads Suite V8i SS2
Typically if you are entering in a specific stationing in the Roadway Designer, it adds that station value into the Key Stations. In the Roadway Designer, go to Corridor > Key Stations and you can select and delete any or all Key Stations that are listed so it only follows the defined stations in the Template drops, and stations for point controls, parametric constraints etc.
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Answer Verified By: Lucky 13
Thanks Chris - I have come across some similar forum responses where people were asking about the increment of the stations after a template drop. There are some older GeoPak answers that indicate there is/was a switch to use a fixed increment or even station. Is that available somewhere in V8i SS2? thanks again for the help, Michael