We work in both Microstation V8 and PowerCivil. Within Microstation there is a command that will set an element to an elevation, and then increment up or down to a new elevation. This command is very useful when setting contours to the correct eleveation. The command will not work in Powerstation, is there a command that will set an element to an elevation and then increment to a new elevation?
From the InRoads dialog box select Surface>Design Surface>Set Elevation. Set the Input Mode to Single, key-in the desired elevation at the bottom of the dialog box at Elevation and then select Apply and Identify the element.
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Answer Verified By: sreng
We are working in PowerCivil and there is no Deisign Surface command. Is it lable as something else?
You can move an element to a new elevation by selecting it, picking your start point and using the key-in browser to enter XY = #,#,[elevation] (as in XY=#,#,850). The number signs (hashtags) tell MicroStation to use the start point X and Y values, but move to the elevation you give it.
This is pretty basic, and doesn't automatically increment, but it can get elements where they need to go. IIRC, PowerCivil doesn't have the surface commands so you may be pretty limited there.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2