https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/97825/right-turn-lane-civil-cell-issuesI&#39;m trying to make a Civil Cell for a Right Turn lane bubble out and it doesn&#39;t seem to work. I can create civil cells without issue for curb returns at intersections, but the transitions to the wider road do not seem to get picked up in the civil cellen-USTelligent Community 12https://communities.bentley.com/thread/287076?ContentTypeID=1Tue, 10 Jun 2014 15:41:34 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:daeb4432-aa05-41fd-9735-a76079a081e6ajs<p>This did work - I haven&#39;t tested it yet where I just describe the dimension of my turn bay by &quot;length&quot; and not &quot;distance&quot;, but starting the offset parallel line from an intersection point, describing dimension by length, reverse curves starting at the end point did the trick.</p> <p>Thanks.</p><div style="clear:both;"></div>https://communities.bentley.com/thread/286959?ContentTypeID=1Mon, 09 Jun 2014 14:54:52 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:98b9035b-eafe-4037-990d-a375b9e6d861Mike Barkasi<p>Your cell cannot work because you have not fully defined where the reverse curve starts and stops.</p> <p>Try locating the reverse cuve at a crossing reference.</p> <p>The other issue I see is the values for the reverse curve need to be locked prior to grouping the cell.</p> <p>Below is a video from M&#39;s site that may help.</p> <p><a target="_blank" href="https://www.youtube.com/watch?v=bg-vz0VtX0Q">www.youtube.com/watch</a></p> <p>HTH</p><div style="clear:both;"></div>