Inroads templates - Ditches

RE: Inroads templates - Ditches

Sagar Polusani — Wed, 26 Jun 2019 06:29:48 GMT

Hi Jacquelyn,

In above mentioned link the video couldn't found.please share it once again

RE: Inroads templates - Ditches

Jacquelyn Pettus — Wed, 06 Aug 2014 14:15:50 GMT

Check out this video on benching:

communities.bentley.com/.../9791.aspx

RE: Inroads templates - Ditches

Jeffery Johnson — Tue, 05 Aug 2014 22:08:44 GMT

thanks good tip, how does the benching work?

RE: Inroads templates - Ditches

Jeffery Johnson — Tue, 05 Aug 2014 22:07:44 GMT

thanks this did it

RE: Inroads templates - Ditches

Wiktor W. — Fri, 01 Aug 2014 06:50:07 GMT

Brilliant! Exactly what we needed, thank you Jacquelyn!

RE: Inroads templates - Ditches

Jacquelyn Pettus — Thu, 31 Jul 2014 18:45:25 GMT

This is a little confusing to describe, so I recorded a video for you.

communities.bentley.com/.../16142.video-fixed-ditch-component.aspx

The final step in the process, which I did not demonstrate in the video, is to create a second priority test end condition that will solve if the existing ground is below the fixed ditch. I attached the template library to the wiki, and I completed this final step in that template.

Hope this helps!

RE: Inroads templates - Ditches

Wiktor W. — Thu, 31 Jul 2014 06:13:34 GMT

Yes, I'd like to have full control over the width and slope of the bottom, backslope and lower part of the foreslope,. The varying element in this template would be the initial part of the foreslope.

Here's a graphical representation of the end condition I want to recreate. Parameters beginning with I... define the slope while B... define the width. So it's the element between E__K and D__1 that should vary.

RE: Inroads templates - Ditches

Jacquelyn Pettus — Wed, 30 Jul 2014 18:48:45 GMT

In this situation, do you need the foreslope and the backslope to be the exact same slope and length at every cross section? What is it that can vary in this template?

RE: Inroads templates - Ditches

Wiktor W. — Wed, 30 Jul 2014 08:29:40 GMT

I'm an MX user moving to SS3 and I have the same issue. I'm trying to make a fixed ditch structure where only the last point intersects with the terrain while the ditch follows a specific slope. I already used the method described by Marc B and it works fine as long as the terrain is flat... When the terrain is tilted both last points of these two end conditions are placed at the interception and the ditch structure in not fixed anymore. (the last point in the inner end condition checks for interception and is set to infinite) Is there a way around this?

Regards

Wiktor

RE: Inroads templates - Ditches

Jacquelyn Pettus — Wed, 16 Jul 2014 21:35:35 GMT

Another idea is to target the surface and then set up a vertical offset. In the example below, the end condition will target a location 10' below the existing surface.

RE: Inroads templates - Ditches

Marc Bachand — Wed, 16 Jul 2014 14:32:52 GMT

Two end conditions will accomplish this. First one in the string should seek existing ground. The second also seeks existing ground, but only the last point is toggled on to seek intersection. This second end condition constructs the ditch.