• How to draw a pipe concrete collar in ORD 10.10 (FDOT)

    Im putting in a new drainage structure that will be connected to an existing pipe. The design involves putting in 4 new feet of pipe at the structure and then attaching it with a concrete collar. Im not sure how I can draw this in ORD. Part of the pipe…

  • Curb Inlet Elevations Too High Above Curb Despite Placing Them Correctly

    I am following the training manual directions on how to place a drainage node, but when I try placing a drop inlet to be at the face of curb it comes in much higher than the actual curb height. I'm not sure what to do to fix this elevation error to get…

  • [OR] Creating SUDA Inlet Cell - Gap between top and bottom when placed

    Hello, I've been trying to create an inlet cell for use with the Subsurface Utilities in OpenRoads (InRoads). So far so good, except when the cell is placed I get a gap between the top and the bottom. Global origins are the same units are the same,…

  • GeoPAK Drainage - Create a Drop Inlet in DLB

    I'm trying to create a standard drop inlet with open sides for use in GeoPAK drainage. The one I'm using is similar to this: ftp://ftp.dot.state.tx.us/pub/txdot-info/cmd/cserve/standard/bridge/ilhste02.pdf My issue is that the DLB…
Communities
Support and Services
Training and Learning
Social Media