Can I assign 'volume' or substrata feature definition for closed meshes generated from Leapfrog, imported in dgn format, on OpenRoads? Imported meshes have volume greyed out in properties. I need to run cut and fill volume report for substrata based on…

So I have ramps on my project. As everyone knows, ramp stationing runs with traffic. Because of this my cut and fill lines in the corridor are upside-down. Is there a way to just change the display for linework created in a corridor.

Hello Everyone I have problem with unsuitable material in cut & fill volumes tool. Remove and replaced material is showned ok, but removed is stretch to the rest of terrain. Files are in attachement. I want to calculate both removed and replaced and…

Hi, I created a corridor, everything is on the right feature definition for design and or for existing if needed. When I run the create Cut and fill Mesh command Openroads is not creating the fill volume a it should. See bellow: The Fill volume (in…

Hi everybody, we can use Civil Analysis/Cut and Fill Volumes command. That's great. But I can guess only how calculations are done. Some parameters are a little bit unclear because this chapter is unfortunately completely missing in ORD documentation…

Hello All, I recently started using ORD and I am trying to obtain Cut & Fill volume and area for a project I am currently working on. On InRoads, I can achieve this by using End Volume Area calculation but I don't think that's available in OpenRoads…

Hi! So for the past 10 years I have been creating profiles and cut and fill plans of landscapes no problem in Powercivil by extracting graphics and building .tin files etc etc from a 3D file. I'm now trying to find a good work flow to do this in the…

hi every one, I need to learn how to create template from scratch (have used them in past but never created or amend one), the template will be for different cuts and fills, different types of ground condition etc, also to calculate cut and fill volumes…