Problem:

VBA's run fine in SS4 but will not run in SS10

Solution:

You need to Re-register the BentleyControls.ocx

Follow these Steps:

1. Exit Power GEOPAK SS10, and any other forms of Bentley MicroStation product
2. See if the following file exists:
   1. C:\Program Files (x86)\Common Files\Bentley Shared\GEOPAK\08.11.09\BentleyControls.ocx
3. If not, use the one attached to this wiki
4. If so, open a command prompt As Administrator
5. Key in the following two commands:
   1. Regsvr32 /u "C:\Program Files (x86)\Common Files\Bentley Shared\GEOPAK\08.11.09\BentleyControls.ocx"
   2. Regsvr32 "C:\Program Files (x86)\Common Files\Bentley Shared\GEOPAK\08.11.09\BentleyControls.ocx"
6. Now open Power GEOPAK SS10 again and see if the VBA’s will run.

To run CMD as Admin

BentleyControls.ocx

Error Message:

 ERROR - ECXAttributes - Unable to locate ECSchema 'Ustn_ElementParams' for ECXAttribute.