How do I automatically create cross sections at Event Points?

Holly Herring — Wed, 02 Mar 2022 17:47:27 GMT

Current Revision posted to OpenRoads | OpenSite Wiki by Holly Herring on 3/2/2022 5:47:27 PM

Product(s):	OpenRoads Designer
Version(s):	10.08.01.33+
Area:	Drawing Production
Original Author:	Holly Herring, Bentley Technical Support Group

Question:

Open the dgn that contains the Baseline alignment used for the cross section creation.
Run the command OpenRoads Modeling > Geometry > Common Tools > Event Point List. Add the Stations to this list that you want included as cross sections
Open the dgn that will contain the cross section sheets.
Select the Named Boundary Civil Cross Section command.
Select the alignment in the View Window.
Select the Event Point List in the pull down to use. If you check "Include Event Points Only" it will only create Named Boundaries for the stations listed in the list.

Holly Herring — Wed, 02 Mar 2022 17:47:14 GMT

Revision 2 posted to OpenRoads | OpenSite Wiki by Holly Herring on 3/2/2022 5:47:14 PM

Product(s):	OpenRoads Designer
Version(s):	10.08.01.33+
Area:	Drawing Production
Original Author:	Holly Herring, Bentley Technical Support Group

How do I automatically create cross sections at Event Points?

Open the dgn that contains the Baseline alignment used for the cross section creation.
Run the command OpenRoads Modeling > Geometry > Common Tools > Event Point List. Add the Stations to this list that you want included as cross sections
Open the dgn that will contain the cross section sheets.
Select the Named Boundary Civil Cross Section command.
Select the alignment in the View Window.
Select the Event Point List in the pull down to use. If you check "Include Event Points Only" it will only create Named Boundaries for the stations listed in the list.

Holly Herring — Fri, 24 Jul 2020 14:25:10 GMT

Revision 1 posted to OpenRoads | OpenSite Wiki by Holly Herring on 7/24/2020 2:25:10 PM

Product(s):	OpenRoads Designer
Version(s):	10.08.01.33+
Area:	Drawing Production
Original Author:	Holly Herring, Bentley Technical Support Group

How do I automatically create cross sections at Event Points or Key Stations?

Open the dgn that contains the Baseline alignment used for the cross section creation.
Run the command OpenRoads Modeling > Geometry > Common Tools > Event Point List. Add the Key Stations to this list that you want included as cross sections
Open the dgn that will contain the cross section sheets.
Select the Named Boundary Civil Cross Section command.
Select the alignment in the View Window.
Select the Event Point List in the pull down to use. If you check "Include Event Points Only" it will only create Named Boundaries for the stations listed in the list.