How to limit your conduit design to only certain sizes

Beebe Ray — Thu, 08 Dec 2022 18:06:53 GMT

Current Revision posted to OpenRoads | OpenSite Wiki by Beebe Ray on 12/8/2022 6:06:53 PM

Product(s):	OpenSite Designer, OpenRoads Designer, OpenRail Designer
Version(s):	10.00+
Area:	Hydraulic Analysis and Design

Problem

How can you limit the design of a conduit so that certain conduit sizes are not included?

Solution

If you want to put a maximum size to the Design run, the simplest method would be to open the Default Design Constraints dialog. Go to the Gravity Pipe tab. On the right, select the Section Size tab. Select "Limit Section Size" and enter a value for the maximum size of the pipe.

If you want to make sure you do not include small pipes or if there are pipes in the catalog conduit that should not be included in the design run, open the catalog conduit by going to Components > Conduit Catalog. This shows all available conduits of the catalog item. If you want to only include certain ones for the design run, uncheck the item from the "Available for Design" column. If you uncheck these, they will not be included in the design run.