Bentley Utilities Designer USER MANUAL or a training course online for BUD.

Hi Murad,
There is a LEARNServer course called "An Introduction to Bentley Utilities Designer" that may be a good starting point for you. You can find it from - learn.bentley.com/.../Public
Hope that helps,
Mike

Thanks Mike,
yes i have seen them before. They where good start. But they show only a sample of this software. How can i learn the rest. Like importing an orthomap tobud like in the example. And cusromize the CU. And customize the work flow. I mean usually there is a USER MANUAL for any software. Where to find it?
Best wishes
Murad

Hi Murad,
There are two user help files linked from within the software. Under the help menu, you will find links to both the utilities and mapping help files. The mapping help contains content covering general mapping functionality, for example, importing the ortho map that you mention above. The utilities help covers the utility specific content, including the customization of CUs (in the section "Managing Design Units"). Unfortunately the last item you mention, configuring the workflow, is not covered by either of these documents. Would you like me to have someone contact you directly to help you with this type of configuration?
Thanks,
Mike

Hello Mike,
I will be grateful if you could contact me to one who can help in that...
and thanks alot for your help :)
best regards
Murad

hello Mike,
hope my message finds you well...
you told me that you can connect me to someone who can help in BUD, Im looking for someone to train me online by skype or other mean, I can pay him for the training, Im looking for electricity application on BUD.

hello Mike,
hope my message finds you well...
you told me that you can connect me to someone who can help in BUD, Im looking for someone to train me online by skype or other mean, I can pay him for the training, Im looking for electricity application on BUD.