I have 2 cables (see attached screen shot). Each has three terminals jumpered. Since the terminals have to be in this set order the jumper lines overlap each other. Is there any way to set the second jumper and so on so that they are not overlapping without manually moving one set outside the other? (as shown in the second screen shot) Physically moving these jumpers only works until the next update of the drawing.
Hi Larry. Does increasing the Jumper interval value on Project Options > Wiring Diagram Settings > Cable Diagrams help?
That's odd. What you describe sounds like what the Offset to CP setting should do, but as far as I know, that setting is non-functional. I also get a node at the ends of my jumper lines instead of the diagonal ends in your screen shots, do you have a customization in place?
Otherwise my jumpers do not overlap and the Jumper Interval does affect the distance between jumpers for me. Are you using promis.e or Bentley Substation? What 08.11.xx.xx version?
this first screen shots the "jumper interval" is 3. in this shot the interval is 10 (I on purpose jumped it up higher) I am using promis-e version 08.11.12.137.
thx
larry
I'm not sure what else to suggest. Perhaps create a small example project that exhibits this behavior, back it up, and upload the backup as described in the Communities Secure File Upload article. Be sure to reply here with the name of the file.