I now have a situation where I try to draw a wire and it actually draws several inches away from where my curser is. Does anyone know how to fix this issue?
1) Check your grid. If grid size is big, the software might snap to nearest grid point.
2) There is a known problem with decimal symbol in Windows regional settings. If it's set to comma "," instead of dot ".", wires are drawn far away from drawing (but it's not several inches, in my case it was completely out of drawing border)
Best regards, Wojtek
SW: Promis.e 08.11.13.96/10.10.00.53
Hi Anna, Please try following the steps in below Wiki Link and check if it helps with the issue you are facing.