Browse By Tags

Hi all. In composite steel girder bridges with concrete decks (continuous span bridges), does RM bridge automatically Calculator effective width of deck to calculate short-term and long-term composite cross-sections? best regards.

Hi all. I hava some question about steel composite brige as follows: 1. To calculator stress point of section, Rm Bridge automatic use short-term section for live load and load case type Non-permanent and use long-term section for load case type Permanent…

Hi all. In continuous beam structures, the allowable downward deflection of the bridge under HL93 load is L/800. So may I ask what is the upward deflection of the continuous bridge structure under HL93 load? best regards.

Hi all. Nice to meet you. I have a model steel composite cable-stayed bridge with 6 span continuos by Rm Bridge V8, 2 side span have 150m, 4 main span is 300m. I don't known about allowed deflection of the bridge. I use AASHTO LRFD standard. If you…

Hi all. I have a question about Reinf crack for prestressed concrete as follows: If you calculator stress bot of section beam in MinMz_Service exceeding allowable stress tension limit is 0,5 x sqrt(f'c), you can calculator reinf area to control crack…

When using RCPIER and the strut-and-tie model for hammer head piers my strut-and-tie model deletes after I exit RCPIER to the main LEAP Bridge Concrete screen even after saving and generating reports. How can I preserve my model upon exiting RCPIER? …

Can LARS Bridge load rate ACROW Truss?

June 24, 2017 Dear Engineers, Greetings for all structural engineers in the world. I'm a bridge engineer from the Philippines and currently connected in a consulting firm. I'm using Leap Bridge Concrete for less than a month and find out that it…

I am using the LEAP Bridge Substructure module to design a pier for a continuous 4 span structure using HS20 LFD loads. In the AASHTO Standard Specifications, it gives you a few options for the loading. One is that you can use a lane load with one concentrated…

I have created a Leap Bridge Enterprise file consisting of a 3 span precast girder Conspan Model, and single column bents with bent caps created in RC-Pier. I'm trying to generate WS loads from the Auto Generate feature. I assume the Wind Pressure for…

One of the new features added to the latest RC-PIER is the comprehensive auto-generation of WS loads and load combinations per the FDOT SDG 2013: An option for WS load auto-generation is now offered under the “Loads” tab. FDOT strength and service…

I am designing a two stage pier wall. There is no option for just a wall in RC pier. Is there a way to trick the program, I have tried a couple of different options but none have worked. The top wall is tapered in both directions and the bottom wall does…