Browse By Tags

I am pretty new to using Leap Bridge Steel, and have a question regarding a project I am working on. I have attached a general framing plan, and was wondering if Leap Bridge Steel was capable of modeling it, mainly due to the partial length girders. The…

Hello Everyone, I would like to use GC in our modeling in OBM in modeling bridge supports because in FC (FunctionalComponents) I encountered some limitations . From what I understood, I should prepare the entire geometry with variables in a separate…

When placing custom pier，concrete pad material option is missing in OpenBridge.

When placing piers，it can be only selected a supportline one by one. If the number of piers placed at the same time is too large, this is a very inefficient operation. Optimization is expected.Thanks！

Hello there. In OpenBridge 2022 R1，I would like to place a barrier along P_4 point of the deck.But when placed,barrier can't follow P_4 point finally.It seems the work point of barrier always recognizes the upper surface of deck,just like following pictures…

Hello there. I would like to get “span name” of Deck by using expression and show it in properties ,just like showing “Span name” of BeamSegment in Fig.1. Figure.1 For this purpose，I tried to use an expression which is "this.GetElement().Deck_SpanName…

Hello, I,m trying to create a Bent where 2 separate bridges meet, is this even possible to model in Openbridge Modeler? Ultimately, I want to transfer the model to LEAP to run the analysis.

Title: SIG Virtual Workshop: OpenBridge – Workspace Configuration in OpenBridge Designer Presenter: Steve Willoughby, Senior Application Engineer, Bentley Systems, Inc. Date/Time: June 11, 2020 2:00 P.M. EDT Register Now This OpenBridge…

I am using OpenBridge Modeler CONNECT Version 10.07.00.50 to make a test model of a bridge that we are currently working on. It's mostly a proof of concept but I am running into a few issues while modeling. The primary issue being that with the relatively…