Browse By Tags

Does anyone know how to clip off part of the civil cell? I used intersection civil cell that joined by a template to form side road, see image. Add clipping reference worked only on the template part, but it didn't work on the civil cell.

I am trying to apply an end condition exception to a template that has a right outside edge of pavement that is controlled by a horizontal feature constraint so the outside edge of pavement is able to vary (for example, at a turn lane taper transition…

When running templates with trigger lines in ORD, I am finding that I cannot have trigger lines on both sides of a corridor that search for the same feature definition. An example would be using a trigger line that starts left of the center of my template…

Hello All. Running 2021 R2. I've modified a KYTC template for my project. The template uses "switch points" to control whether the end condition and sholder is displayed (for use at intersections, entrances, etc.). My corridor is set up and I used the…

All, Was wondering if any of you have ever experienced this. I am in the IDOT (Illinois Dept of Transportation) workspace. As shown below, in my template library, the aggregate is modeled with feature definition. Whilst, in Cross Section Viewer and…

I'm using Power Geopak V8i SS10. Very new user. I modified my corridor a little bit, changing templates and a few things. It doesn't appear that my civil cell is tied to my corridor anymore? I had placed my civil cells to tie to my "edge of pavement…

I'm experiencing a problem in open roads designer in which my corridor is drawing duplicate components. It seems to occur whenever a change in the profile is made. A new component is drawn but the old one remains still in place. See below. The component…

I am running InRoads SS4. I am trying to calculate cut but only in a certain part of the road. I have changed my template so I can ignore the components I need to in order to get that certain section. My issue is the following: there is a column in the…

The reference element (centerline) for my corridors has become corrupt. It I touch the corrupted element UStn crashes. It is corrupt in my backups. It there a tool/method that allows me to change the reference element of a corridor to a different element…

My template is set up with priorities to solve for several cut and fill conditions. The guardrail end condition has the highest numerical priority and solved last. Naturally, this creates "pockets" of the guardrail shoulder condition along a corridor…

Are there any Civil Cells for the roundabouts and segmental bridge. Thank you.

How do you change the alignment on the corridor ?

The geometry of the design has changed. I have an edge of pavement (Arc) the need to be removed. It was an element that was reference to the corridor. I try removing any rule. But still I cannot deleted

I am trying to crate a shape to clip a Model but it cannot Transform this element It Has a Rule!

I am using SS4 for cross sections. I have a T- intersection the cross section at the major street at the intersection is done, the minor I have to do some reconstruction and then milling and resurfacing. In the old Geopak I just had station limits. ei…

In the old geopak the shape superelvation was used to crate plateau intersection. In SS4 is the recommended practice the same? Also if there is a model with a super elevation section can this be modified (extended or shrink) to make room for the plateau…

In a FDOT modified template the pgl right is plotting correctly but the PGL left has a constant error and when it get to the super elevation section it gets worst. Those anybody know why the cause PSL_1.LT_PVT_EOP_IN is not fallowing the PGL_LT.PGL…

Hello, I'm having issues dropping a barrier wall on my template design. I can't constrain the left bottom point (TP) because it gives me an error, see attached image. Any suggestions on how to drop the barrier wall on the template and how to constrain…