Browse By Tags

I would like to use the InRoads Bridge Geometry tools to quickly layout girders on a tightly curved bridge. This would be a very useful tool if I could get it to work. Instead of manually drawing girder lines and checking max/min deck overhang, max/min…

i prepared a grid of lines and i wanted to place the profile inside the grids since the alignments are all short segments for a station yard with a small length and i want to have some kind of order for my review. so what happened was in the past i was…

Dear All, I am Creating a Profile By Using the ASCII file with .se file, when annotating this file Only Station showing in the Drawong Elevation Not Showing, What is the Problem, any other procedure is therre to shwon station elevation both in profile…

i prepared a greed of lines and i wanted to place the profile inside the grids since the alignments are all short segments for a station yard with a small length and i want to have some kind of order for my review. so what happened was in the past i was…

Dear All I have thee doubts in BRT. 1. I am importing survey data and creating surface. and I am creating a Horizontal alignment. My doubt is I need a Tentative Vertical based on the ground surface. is it possible or not. 2. I have a Cross…

Dear all, I am using BRT V8i with microstaion V8i Select services-2 in the i am facing a small prblem i.e when i am using BRT command Like Move PI,Insert Pi when moving the geometry Alignment if i use microstation snaping tools to snap with end…

Dear All Thankfull for Responding my Questons I Have a Another Doubt and Problem, i am Creating cross sections in BRT it is coming good, When I am Annotating the Cross sections the offset and eelevations are showing at ground change points only…

Hallo, i want to create a surface in the roadway modeler using an alternative surface option.But I want this surface to be perpendicular to the profile. For example the point for the alternative surface is at 1m distance from the vertical alignment, I…

Dear All, I am facing a problem with rail elevation this is most importent for me to show rail elevation in the profile, our railways did'nt accept with out rail elevations, for rail elevation again i am going to auto cad. I am creating a horizontal…

I have a data that contains the Coordinates of Beginning of Project, Tangent to spiral, Spiral to curve, Curve to Spiral, Spiral to tangent, radius of curve, length of curve, length of clothoid and I want to create an alignment from this points by importing…

When creating an alignment on powercivil SS3 using the civil tools, object manipulators disappear when the alignment is very long, only manipulators for PI's remain and the ones for radius, lines, etc do not show except for the first few elements. Has…

I have been looking at a bunch of forums trying to locate a solution to my problem, but have not found what I am looking for. So I am asking for some advice. I have created a Horizontal alignment from cogo points that have and XYZ location. When I…

Hello, I am trying to transpose my geometry after I have already modeled my corridor in roadway designer. Geometry -> Utilities -> Transpose Geometry Geometry -> Horizontal -> Stationing This was successful-- the next step was not. Opened…

Running InRoads V8i - if I "check in" a horizontal alignment after making changes to it, must I save the geometry project in order to preserve my changes?