Browse By Tags

In Leap Bridge Steel, I have a curved bridge, so the girder lengths are not integer values. Under the Member Definition tab I'm unable to manually input flange plate lengths to a sufficient decimal in order to be able to run analysis (see below for the…

Hi, In the article below it mentions that the issue where "Distance from top of concrete deck to the neutral axis of the composite section at the plastic moment was incorrectly calculated." is fixed. However, I'm still running into this problem when…

Hello, Is it possible to change the category in which the program evaluates load induced fatigue at the cross-braces (LRFD T6.6.1.2.3-1)? I see in the fatigue reports that the program is currently evaluating fatigue at the braces under C' for both welded…

Im in LEAP Steel and have started a model all the way up to entering the supports. I click ok and get error message "Roadway limit is breached". All my supports are within my begin and end station, I am doing the same as I have with successful models…