Browse By Tags

  • RCPier P-Delta Analysis increases axial forces in the column.

    When running analysis with and without P-delta I noticed there is a substantial increase in the axial column force when P-delta is applied. At the node 1 the difference is about 300 kips. What could be a reason for such an increase? Any insight is appreciated…

  • Shrinkage Strain Load & Moment capacity error - LBC Substructure

    I have bent that is being constructed in two phases so some shrinkage will happen on the first phase before the next phase is constructed. In the final condition, I could assume the entire shrinkage strain is applied to both sections but that will be…

  • LEAP Bridge - RCPier Centrifugal Forces Considerations

    Hi, There are cases where centrifugal forces produce a moment that actually counteracts the critical moment in the column, does RCPier consider effects due to vehicle cases without centrifugal forces as provisioned in AASHTO Spec (See below excerpt…

  • LEAP RC-PIER P-delta effect in load combinations

    When checking Show P-delta Effects in the Analysis tab, are the values shown represent values with p-delta effect? For example, are the column/shaft moments magnified with p-delta factor in these load combinations (with a "C" on the end of the LC#)? If…
Communities
Support and Services
Training and Learning
Social Media