Browse By Tags

I have generated cross sections for a railyard using one alignment. Running alongside this one “main” alignment are several other alignments comprising the tracks of the railyard. These alignments all contain 3D profile information. Ideally, I would…

Hello to everyone, I would like to know if someone knows if it is possible to create a longitudinal section of a bridge along its alignment so that if the bridge is in horizontal curve I can get the real longitudinal profile? Perhaps it is possible…

Hello. I am new to roadway design. I have problem about creating crossections that some of end conditions are above or below to surface. I created 3 different alignment. One is using text import wizard, horizontal and vertical alignments. One is from…

Hello! This problem occurs very often. Typically when I use "project to surface". If I turn of my control points of cant and alignment, the template goes down, on the level of the wrong working element I assume that the template is placed…

Hello, I have an existing alignment that I am using as a center line to cut my cross sections, and I have a second alignment (edge of road) that I need to show as a point on the cross section. I need to show the distance and elevation of the second…

I have been looking at a bunch of forums trying to locate a solution to my problem, but have not found what I am looking for. So I am asking for some advice. I have created a Horizontal alignment from cogo points that have and XYZ location. When I…

In version 08.09.01.45 Negative shoves all the annotation to the left of the initial point, Positive shoves it to the right, and Equal is supposed to array them out from the middle point. In 08.09.08.06 and 08.09.02.16 the "Equal" seems to be broken.…