Browse By Tags

Dear sir/madam, I have a question about UBC3D model for my dynamic analysis model: Does the "G" parameter (Elastic shear modulus, which is calculated by the kGe shear modulus factor) equal to G0=(Vs^2*(Unit weight/g))? If so, isn't this model…

Dear sir/madam, I'm working on a dynamic analysis of a multilayered soil profile improved with stone columns & piles. I have some questions regarding the parameters: While using the UBC3D model for liquefaction, we know that it overestimates the shear…

Dear sir/madam, I'm working on a dynamic analysis in a multilayered soil profile improved with stone colums & piles. I have some questions regarding this analysis: 1) To evaluate the liquefaction, i should use the dynamic with consolidation calculation…

How to measure uplift in a tunnel due to liquefaction in PLAXIS 2D?

How to simulate cyclic triaxial test in Plaxis software? Is there any particular example video for the same? And how can I observe pore pressure ratio with time?

Why liquefied points are observed in soil while using advanced constitutive models PM4sand and PM4silts before seismic loading? The liquefied points were observed in static phase only

I have to model an existing tunnel and perform the analysis under seismic loading. What will be the phases for staged construction in PLAXIS 2D?

I am currently working on a liquefaction analysis using the PM4Silt and PM4Sand models for a layered soil model in PLAXIS 2D. However, I have encountered an issue where the liquefied points are observed in the static stage only before the dynamic analysis…

Hi there, I am in the process of conducting a dynamic analysis to asses the stresses and strains in a secant wall during an earthquake event. The parkade is about 28m deep. The water table is close to the surface and the excavation wall consists of…

I just doing a simulation for liquefaction on gentle relief slope with the dynamic load is 50s which consist 0.01s each data. I use PM4Sand for the constitutive model applied on the sand layer also HS Small for the clay. Currently I set the Max steps…

Good morning, Is it possible to set manually the value of the parameter h0 for the PM4Sand model? The value is computed internally with equation 2.31 of the PM4Sand model manual. Thank you in advance, Andrea Balia

#PREdesign #Firstdesign #not-final-design Hey, I'd like to back to give additional informations about my last question. As i have already said, i'm geologist, student in M2 geosciences for energy at Paris Cergy University. For my master thesis,…

For the same model Mohr-Coulomb, HS and Hs small model is giving positive pore water pressure but the UBC3D-PLM model is giving negative results of excess pore water pressure. Is there any problem in software or I am doing something wrong.

I want to apply (input) a dynamic load of sinusoidal wave which is having a frequency of 20hz and amplitude of 5m/s2 at the base of model how can I apply that? Secondly, how can I use UBC3DPLM model for liquefaction and how can I get pre and post liquefaction…

I am working on liquefaction analysis. Can you tell me how and on which surface, I should apply the earthquake load? Surface displacement or a surface load? The geometry is quite simple, with foundation soil 45*45*6 and dam over it of height 4.5. Moreover…

Hello, Good afternoon. I am working on my Master's dissertation with Liquefaction Analysis from Earthquake Loading and I have three questions about my modeling. 1) What should be the correct dynamic boundaries to use on this modeling? I am simulating…