Browse By Tags

My WaterCAD version has a specific limit of 10,000 pipes for computing a scenario. I currently have 10,966 pipes. Due to the nature of the GIS model that was imported in the model builder, many of these same diameter pipes were made up of multiple polylines…

When I try to use the command "place a lateral" it does not work out for me. I use an existing stormwater pipe, adding a new pipe and node with the same type as the existing pipe. The only product of the command is a point on the correct level, but no…

Hello, When I use a command chain as follows, the conduits direction cannot be change. How can I solve this? I create a line going from point A to point B (direction from A to B). Then I use the command "Extract Utilities from Graphic" command creating…

Hi! I am modelling a sewage pipe system where I cannot place a node / lateral connection on an existing conduit. The placement of my pipe system is obtained using the "Extract utilities from graphics"-command whereas the end and start point of the graphic…

I have transfered a drawing from AutoCAD to WaterCAD V8i and I see the pipes and also de nodes. The problem is that although I see nodes in some pipes that either cross other pipes or that stop (connect) to other pipes, but I'm not sure if there is connectivity…