Browse By Tags

  • Corridor Templates - Automatic update of constraints

    I have this template and would like the point BallastBtm to automatically move horizontally based on the relationships between other points in the template, specifically to find the lowest point from SB1 TO SB8 and move horizontally to x point = 0 (e…
  • Issues with Tunnel Templates | Closest ComponentConstraint | Tunnel Component rendering

    Hi guys, I'm currently working with this template, observe the selected Line component, it has two ends right and left as marked below. Issue #1 My goal is to project the line ends to the tunnel inner ring. The level of this line will vary depending…
  • Templates - Establishing relationship in Tunnel Templates

    Hi folks, I'm trying to establish a relationship between Two Points and one component. My goal is whenever " Single_Track_LR " go up or down, " SC_Left_Edge " point should also go up or down vertically but get attached to " Tunnel_Inner_Face " component…
  • Transitions between templates

    Hello, Is it possible to create transition between templates properly, when I use point control in my corridor (in templates, which are before and behind my planned transition)? As example I tried to make a correct transition using Single track - ballasted…
  • Adding template by template drop doesn't work.

    Hello, I've started to work with OpenRail. Previously I was working with BRT SS2. I have an issue with adding templates to my corridor. I have horizontal and vertical alignment, corridor added. Previously I've opened template library. When I want…
  • Circles in Section (ORLD)

    Hi Everyone, I hope You are doing well, and still healthy. About my question, I made a template for tram bridge, and there are cable pipes in the concrete. So I made it circle on template but on 3d view it shows the circles like triangulation…