Browse By Tags

  • OpenRoads

    OpenRoads Designer is a comprehensive and fully functioned detailed design application for surveying, drainage, subsurface utilities, and roadway design that supersedes all capabilities previously delivered through InRoads, GEOPAK, MX, and PowerCivil…
  • Best way to create utilities from many data points

    I have roughly 800 points with northing, easting, elevation, depth below grade, stationing, and offset from my alignment information. The depth below grade varies from point to point otherwise the solution would be quite simple. There are roughly 8-10…
  • ORD Drainage and Utility. Pipe length not accurate when drawn.

    When i place a pipe the length will show 6' but when i use the measuring tool or element property for some reason the length is doubled. Any reason for this?
  • Is there a way to set the cover depth (with respect to active terrain) for utility (Electrical Conduit) once it has been created in OpenRoads ?

    I know that we can do this while using the command "Extract from Graphics", but, is there a way to reset the cover depth once after creation of the conduit.
  • ORD - How do you show utility that are parallel to the center line in road profile

    Hello, I need some guidance on how to display utilities on the roadway profile. the way I've done it so far is by creating a profile run of my utility. However, this only works on one specific file, and I am not able to reference this file in the…
  • Last Mile Utilities - Set of utilities for OpenRoads & OpenRail Designer

    Last Mile Utilities MDL Application - Set of utilities for OpenRoads & OpenRail Designer Product: OpenRoads & OpenRail Designer Version: CONNECT Environment: N\A Area: Programming …
  • Drainage and utilities - Extract Utilities from graphics

    Hello I'd like to put a 2D utilitiesmodel into 3D by extracting the graphics. There are a few issues I see: It isn't possible to add a diameter to the 3D element. It is possible through the description, but that is unlogic It isn't possible…
  • Openroads: How to Display Existing Utilities in Cross-Sections?

    Currently, I have my existing utility lines in 2d view with a feature definition and plotted them at an assumed depth of 3' below existing ground in profile view and set as active profile. Typically, in SS4 and SS10 this worked in terms of displaying…
  • Should I use OpenRoads to design water and powerlines for an OpenBuildings project?

    This is a general question about which Bentley product should be used: I need to create 3D models for underground utilities including: water lines (including fire hydrant connections), power lines, and CCTV. The entire project is a major building…