Browse By Tags

Hi, I know there has been a bug where the EAV table does not show up when using the 'model annotation' tool in the XS drawing model. Is there a workaround for this? Thanks in advance.

Hi, I have been trying to export XS from my model and I seem to run into 2 problems: 1. I cannot figure out how to display the existing surface only per station rather than the full 3D surface model. Inside the red box you can see the template drop…

How can you control the spacing between cross sections on a sheet in ORD ?

I need to convert old cross sections into DTM. Thank you.

I am using the FDOT SS4 Existing 2 lane Cross Slope templates to analyze the existing cross slopes of the road. I have used this a few times before on other projects and the report that Microstation gave me was correct. For some reason this time the report…

Hello, I created a cross section model using FDOT XS_20_10 preferences. I started from the Cross Section File (Pattrd Model). My references are design, existing features and terrain file. The cross section is created with no problem except all the…

How can we draw R/W lines in XS when R/W lines are outside existing (active) terrain?

The slope/end condition lines are not showing up when I create cross sections. The lines show up in the corridor, 3d model and dynamic cross sections. The screen shot below shows the points of the ditch bottom and where the back slope meets existing;…