An issue came in today that I think will benefit the community to see troubleshooting techniques as we work toward a resolution.
I am getting several .NET Framework errors when launching GEOPAK Civil Engineering Suite select series 3
Applies To
Product(s):
All
Version(s):
XM and Higher
Environment:
N/A
Area:
N/A
Subarea:
N/A
Original Author:
Subscription Utilization Team
Introduction…
IMPORTANT FOR CAD ADMINISTRATORS
With the release of MicroStation CONNECT Edition Update 4 we have made several enhancements to the Configuration setup during Installation and while using MicroStation CONNECT Edition Update 4.
The changes are especially…
Product:
MicroStation
Version:
All
Environment:
N\A
Area:
Levels
Subarea:
Level Audit
Overview
Since the introduction of the new level system in MicroStation, levels can be deleted. Given the…
We're receiving the following message above when opening a PSET using Print Organizer (MicroStation SS4).
And we're also receiving the following information message:
"There was no endpoint listening at
net.pipe://locahost/21ff1313-4a50-411a-8a6e…
We have computers with the following software installed:
MicroStation (SELECTseries2) 08.11.07.443)
InRoads Group V8i (SELECTseries2) 08.11.07.428
GEOPAK Suite V8i (SELECTseries2) 08.11.07.427
When attempting use Geopak to draw cross…
Product:
MicroStation
Version:
CONNECT
Environment:
N\A
Area:
Configuration
Subarea:
User Preferences
Problem Description
How to enable Position Mapping shortcuts and make them visible in MicroStation…
Product:
MicroStation
Version:
V8i, CONNECT, 2023
Environment:
N\A
Area:
DGN
Subarea:
General
Background
A debug file is very useful when investigating configuration issues in MicroStation…
I just started a DSGNRD01 file with a new design and I am not sure what I did, but I keep getting .NET Framework errors. I have gotten these before and been able to just keep clicking through the errors until I can get back to work, but I am getting tired…
Hi all; just loaded an new computer with MicroStation SS3 and InRoads SS3 and get a .NET Framework error on running. Originally ran MicroStation by itself and worked fine.
Product:
MicroStation
Version:
V8, XM, V8i, CONNECT, 2023
Environment:
N\A
Area:
Administration
Subarea:
N\A
Command Line Parameters
The easiest and most reliable way to determine which command…
Dear members of Bently Communities,
We are working on add-in which should support some specific versions of MicroStation. As I know each installer has product name and build number (i.e. 08.11.07.159). We would like to support only some versions for…
Here's a little post to add some clarity. I have had several colleagues mention that they would better understand CONNECTs workings if they had a flowchart. This is what I came up with - enjoy:
hey folks,
Just wanted to put some information out there about a few variables. This is not a complete list, it's just a few that I found and thought I would share.
In the newly released MicroStation CONNECT Edition there are a few variables that…
Product(s):
InRoads, MX, GEOPAK
Version(s):
08.11.09+
Area:
Basic Settings
Question:
Which version of InRoads/GEOPAK/MX will run on MicroStation CONNECT?
Answer:
OpenRoads Designer CONNECT Edition is currently in development…