How can the unifier be used between different Families, for example, the Family 'beam' and the Family 'floor', for DEM drawing extraction?

For example walls we use 4 different cells for the littera ( Item Type ). Up, Down, Right, Left To save a lot of time i would like to make macros to choose them. I tried to record but it stops after open the "Annotation tool settings" dialog. How…

I'm using AECOsim SS5. I'm trying to generate sheet views from a 3D model. For Structural Framing Plan, using double lines to represent structural members, the double lines come out oversized - see below. There must be some scale factor that isn't set…

Dear all, This is my Model : I have taken Clip Volume as below : Is there any method / command / way to create an extraction of this cut sections which is in different angles/Planes. In one direct 2D view !. Which could be similar…

Hi everyone. This is my first time to fill in my question here. I am very grateful if someone can help me solving this question. Now here it is: I used the AECOsimBD ss5 with 747 version and put stairs in my model. When I cut the stair with Clip Volumn…

Good Morning, I'm new in aecosim world, I have a simple question but hard to resolve for me. When I have a solid like a cube with a family, part and layer such as cocrete, and I put its horizontal section in a sheet with a 1:100scale, and its vertical…

Hi All Apologies if this has cropped up elsewhere and once again if it's a very simple problem but... We are using AECOsim Building Designer V8i (SELECT Series 3) through (Projectwise V8i SELECT Series 4) and are producing our architectural drawings…

Hi, Trying to go from DV's in Bentley Architecture into merged 2d CAD drawings is giving surprisingly unsatisfactory results: We can’t seem to find one viable method for 2d drawing extraction that maintains a sufficient level of information such…